Reply to thread

Message: <blockquote data-quote="Brianwill" data-source="post: 197" data-attributes="member: 15">This product is for making stencils. A stencil is basically the outline of a picture with the negative part missing. To make the stencil you scan the hologram off your id, then convert it to an all black image. Next you print the image on a transparency. A transparency is a transparent sheet of plastic meant for inkjet printers or lasers. Then you take the transparency and tape it to the Photo-EZ. You put it out in the sun and all the areas of the material not covered by the black negative of the holo cures. When washed the part covered by the negative washes away, leaving you with your stencil. You will want to order the high resolution material. This product can be ordered from cBridgeand more information can be found there.As for the painting material, the two main ones are Interference Gold (Fine) made by Golden Acrylics and PERL-EX DUOTONE. The latter of the materials work best because of the fact it reflects two colors of the spectrum. Perl-Ex comes as a powder and preparation is needed. These paints are transparent when viewed from straight on. When viewed from different angles you see different colors depending on the particular colors of the paint. Perl-Ex comes in Duo Red-Blue, Duo Blue-Green, and Duo Green-Yellow. Perl-Ex is available in a lot of places here is one: <a href="http://www.sierra-enterprises.com/pearlex.htm" target="_blank">http://www.sierra-enterprises.com/pearlex.htm</a>You have to buy a Transparent Base made for paints to prepare the Perl-Ex. A good one is Speedball Transparent Base. You mix in a 1:50 ratio. 1 part Per- 50 parts base. If you are using Golden acrylics then you use a 5:1 ratio. 5 parts paint 1 part base. When applying the paint in the stencil, you should use if possible one of those brushes made for screen printing. It is like a pencil but with a flexible tip. A sponge can be used but extra care needs to be taken when applying. You want to apply a very thin amount and practice will be needed to get it right.On a lot of the new ID's there is a multicolored hologram that reflects the full spectrum (like a rainbow). This is especially true of most of the Canadian ids. What you do is pick the two most dominant colors and buy the matching Perl Ex colors. This will be good enough to reproduce the holo. The holo can be put directly on the finished ID or before lamination on the inside of the pouch. If you choice is the inside then remember to put it in the reverse.15. Then, you’re ready for the finishing touches.It is recommended that you sand the edges of the hologram with a very fine grit sandpaper. This removes the jagged edges of the synthetic paper. You should lightly sand the front and back of the id to give it a more worn look.16. Lastly, these instructions were to make a 30 mil drivers license that resembles a PVC card. If you want to make something thinner that bends corner to corner like some ID cards, you can remove the front part of the butterfly pouch and simply laminate the back of the pouch with the synthetic paper. Many machines use this method, but it can be accomplished manually. You can also replicate signature strips by scratching the surface of the butterfly pouch with sandpaper.17. Have fun and don’t be an idiot with your ID.</blockquote>

Name

Verification